The Creedmoor Forum

I picked up 12,000 SR at Graf and Sons a month ago for about $70 z a thousand.

Midwayusa had some factory second 147's 500 for $145 I grabbed a couple boxes.

I have many gassers consistent 3/4 MOA is achievable are there some guns out there capable of better probably some. Now when I say 3/4 MOA this is 10 five shot group's averaged together not a single bullet called as a flyer BS either. When put to this standard those 1/2 MOA guns seem to evaporate or maybe they just identify as something else that day???

You may or may not need to turn the necks depending on the chamber of your rifle.

The difference in an AR-15 rifle length has tube and a AR-10 rifle length gas tube used by some barrel manufacturers is a 1/4" longer the AR-15 tube just barely makes it into the gas key and will short stroke the gun. Measure the distance on you old barrel and new barrel to verify they are the same. If they are then get a lighter buffer.AR-10 in 6.5 Creedmoor are normally over gassed so I suspect your gas tube is 1/4" short. Best to order gas tube from the same place you got the barrel from on AR-10's

If I didn't have a 385yard range here at the house for load development that little press would be the bomb diggity for tinkering at the range.

IDK about temp stability but Superformance has delivered excellent accuracy for me. So much so I picked up an 8lb the other day because who knows when I'll see H4350 again on the store shelf. My in-law only uses Superformance in his RPR.

I had a very badly copper fouled barrel that I fooled with Sweets trying to clean finally gave up on Sweets got some KG it worked to clean out the copper fast. Now I just keep the bottle of Sweets around to run a patch once in a while after the KG to see if it shows any color.

I keep all my primers in sealed ammo cans with desiccant packs. I stored some in the garage unprotected for about 10 years and had a coupe misfire when I went to use them.

Nice place

I have a 26" Krieger on mine it's reasonably accurate MOA maybe a bit better. I do recommend the JP high pressure bolt and order your barrel and gas tube together from the same place so the gas tube is the proper length.  Remember there are no standards on AR-10's so everyones parts are a little different upper receiver and hand guard rail height may not match from manufacture to manufacture.  Mine are about an 1/8" mismatch

Pretty liberal up there in Wisconsin. I know of one guy that has I don't know maybe 8 DUI's they give him a slap and send him on his way. Just waiting for the day he kills someone drunk driving. I will without a doubt testify for the victims family that the state of Wisconsin is an willing accomplice to their lose. Just like in this case willing accomplice to multiple murders and mayhem. They will be "nothing to see here" we didn't just cut this guy loose for the similar offense a couple weeks earlier. This is absolutely how they operate up there I had to move 20 years ago from there couldn't  take the libtard crap any longer.

I'm sitting on a pile of them. I've always tried to keep about 10,000 primers on hand because of shortages after this BS blows over I may up my number to 20,000 primers. I do the same with 22 ammo I can never have to much I've got three boys.

We had a Polaris 4 seater with dump bed loved the idea  of it but IMG expensive anytime something was wrong with it we finally got rid of it. I would maybe consider one of the mini trucks it would be about the same in use as the 4 seater side by side  but hopefully cheaper to repair.

I think those Ruger Americans are fine rifles for the money and will get the job done. If your not shooting past 500 yards 4831SC is perhaps the most accurate powder I've tested.