Skip to main content
Topic: Hornady 6.5 147gr using Alliant 19 (Read 120 times) previous topic - next topic

Hornady 6.5 147gr using Alliant 19

Is there anyone out there using Alliant 19 with the Hornady 147gr ELD - Match. I am looking for a recipe to match the factory stated 2695fps velocity but using the RL19 instead of the Hodgson H4350 (factory use)?

Or can suggest another Alliant product with a recipe to use with this Hornady ammo?



Re: Hornady 6.5 147gr using Alliant 19

Reply #1
In the 11th Ed of the Hornady Reloading manual, 42.2 grains of IMR-4831 is the max load for a 147gn ELD-Match bullet. RL-19 is very, very close to the same burning speed as the IMR powder. I think using 39 grains of RL-19 is a safe amount with RL-19.
Of all the gin joints in all the towns in all the world, she walks into mine.
Every man has got to know his limits.

Re: Hornady 6.5 147gr using Alliant 19

Reply #2
I'd start lower and work up.

I think we all need to exercise extra caution in sharing load information like this, specifically estimations based on past experience with similar powders with no known published data.

I'm not against helping each other out but things like lot to lot inconsistencies and different barrels brass and primers etc. can greatly affect what's a safe load in one rifle and what's not in another.
Dave

 

Re: Hornady 6.5 147gr using Alliant 19

Reply #3
Is there anyone out there using Alliant 19 with the Hornady 147gr ELD - Match. I am looking for a recipe to match the factory stated 2695fps velocity but using the RL19 instead of the Hodgson H4350 (factory use)?

Or can suggest another Alliant product with a recipe to use with this Hornady ammo?




RL16 is my go to powder for the 147 ELD-M. 

I did some ladder testing with RL19 a couple of years ago.  It is faster than either RL16 or H4350, but lacks the temperature stability.  When I did my testing, I based it on Sierra's testing of RL19 with their 142gr and 150gr.  In both cases, they listed loads up to about 45.6gr.  The lowest thing I tested was 43.8 gr and even that was running 2730 fps.  My best guess would be 2700 would be below 43gr.  So start low.  My tests were done with Federal 210 primers and a 24" barrel.

Again, as HufD63 said, start low.  Even the best powders can vary between lots.  Your mileage may vary. 

Re: Hornady 6.5 147gr using Alliant 19

Reply #4
Good advice by all to start low and watch for the pressure signs. Appreciate all the advice

Re: Hornady 6.5 147gr using Alliant 19

Reply #5
I’ve tried RL 19 several times with 140 grain bullets.  For whatever reason I can’t seem to come up with a load that shoots consistently.  Perhaps you’ll do better with a heavier bullet. Let us know how it works out.