I have a mea culpa to come clean on: The printer I use for my targets is a new Brother laser, it replaced a Samsung laser that passed away after many years of service. Unbeknownst to me, the new printer does not allow for tight border margins, it just changes the scale of what actually prints on the page, in other words, an inch is not an inch . When I posted my last target I assumed each grid on the page was in fact 1"x1", nope, more like 0.95866"x0.95866". Because of the way MOA calculations are made, some targets had higher MOAs, some lower, not by much but enough to p*ss me off .
Anyway, mistakes happen, lesson learned, "trust but verify", "measure twice, cut once" and so on, lol.
Anyway, mistakes happen, lesson learned, "trust but verify", "measure twice, cut once" and so on, lol.